|
|  ROTATORS - HYGAIN ROTOR LOWER MAST ADAPTER 
This adapter, HyGain P/N 5030500, fits any of the Ham type rotors and attaches to the bottom of the rotor with four 1.25 inches stainless bolts. (provided). It needs the clamp plate kit which includes two u-bolts and the plate.(not provide) to complete the clamp assembly. $35 shipped. I take PayPal, Postal MO and check
Listing #1757786 - Submitted on 02/03/26 by Callsign W6XI, Modified on 04/05/26 - IP: ip68-109-162-111.ph.ph.cox.net
Click to Contact -- Click Here to View Picture -- Send this Ad to a Friend
ROTATORS - HYGAIN ROTOR LOWER MAST ADAPTER
This adapter, HyGain P/N 5030500, fits any of the Ham type rotors and attaches to the bottom of the rotor with four 1.25 inches stainless bolts. (provided). It needs the clamp plate kit which includes two u-bolts and the plate.(not provide) to complete the clamp assembly. The two U-Bolt holes at the top of the unit, shown, are slightly larger than the stock U-Bolt holes by approximately 1/8 inch. This should not affect the strength of the assembly. $30 shipped. I take PayPal, Postal MO and check
Listing #1757790 - Submitted on 02/03/26 by Callsign W6XI, Modified on 04/05/26 - IP: ip68-109-162-111.ph.ph.cox.net
Click to Contact -- Click Here to View Picture -- Send this Ad to a Friend
ROTATORS - CDE HAM-M ROTOR CONTROL
This rotor control will work with all the Ham series rotors. It has been tested and works fine. The case housing has some markings from many years of use. The meter works as it should and the Zero pot works smoothly. $35 shipped. I take PayPal, Postal MO and check.
Listing #1757799 - Submitted on 02/03/26 by Callsign W6XI, Modified on 04/05/26 - IP: ip68-109-162-111.ph.ph.cox.net
Click to Contact -- Click Here to View Picture -- Send this Ad to a Friend
 RADIOANQ - Hallicrafters SX-28
Very nice SX-28 that has been recapped and several out of spec resistors changed. The SX-28 works very well with very nice audio. Only thing is there is a low hum on strong signals, might be a bad tube or a leaky ceramic cap I'm not sure, not really a nuisance but wanted to be honest it is there. I'll sell this SX-28 for $375 picked up in NW Indiana. Please feel free to contact me with any questions.
Listing #1764143 - Submitted on 04/05/26 by Callsign WV9R - IP: c-67-173-66-205.hsd1.il.comcast.net
Click to Contact -- Click Here to View Picture -- Send this Ad to a Friend
MISC - PJ-068 COLLINS AND DRAKE AUDIO PLUGS
Two of the three plugs are used but still very functional. Solder lugs on two units are still attached. No solder lugs on one unit just needs to be hard wired with the screw still attached. $15ea shipped. I take Paypal, PMO and check.
Listing #1757803 - Submitted on 02/03/26 by Callsign W6XI, Modified on 04/05/26 - IP: ip68-109-162-111.ph.ph.cox.net
Click to Contact -- Click Here to View Picture -- Send this Ad to a Friend
MISC - 49 PCS 6A10 1000V Piv 6 AMP AXIAL RECTIF
These diodes are new unused surplus they make great power supply rectifiers. $20 shipped. I take Paypal Postal MO and check
Listing #1757805 - Submitted on 02/03/26 by Callsign W6XI, Modified on 04/05/26 - IP: ip68-109-162-111.ph.ph.cox.net
Click to Contact -- Click Here to View Picture -- Send this Ad to a Friend
ROTATORS - HYGAIN ROTOR CONTROL REPLACEMENT METER
New unused meter movement for Hygain rotor controller. This meter fits Hygain CD 45, Ham 4, and Tail Twister series controllers. The meter comes with a North centered back plate but included is a South centered back plate. The meter is in the original container. $49 shipped. I take PayPal, PMO and check.
Listing #1757808 - Submitted on 02/03/26 by Callsign W6XI, Modified on 04/05/26 - IP: ip68-109-162-111.ph.ph.cox.net
Click to Contact -- Click Here to View Picture -- Send this Ad to a Friend
ANTHF - ANTENNA MATCHING INDUCTOR
This ceramic coil form, with link coil assembly coil wound on it was to be the matching assembly for a shortened 10 MHZ antenna. It could also be use to just add inductance to most any antenna. The form is 2.5 inces in diameter and has 32 groves for windings. The windings on the form are three turns for the Pimary link and 13 turns for the secondary winding. The windings are made of 10 and 14 Ga. solid copper wire. $27 shipped I take Paypal, Postal Mo and check
Listing #1762300 - Submitted on 03/17/26 by Callsign W6XI, Modified on 04/05/26 - IP: ip68-109-162-111.ph.ph.cox.net
Click to Contact -- Click Here to View Picture -- Send this Ad to a Friend
ANTHF - MOSLEY S 402M DRIVEN ELEMENT INDUCTOR
This inductor was redesigned and used on the S402 and S403, driven element, with great success. It is a balanced input to the antenna rather than the unbalanced, original inductor.
The unit will need to be sealed up before placing it out doors in the elements. The seal caps are available at most hardware stores that deal with PVC pipe. $40 Shipped. I take PayPal, PMO and check.
Listing #1762309 - Submitted on 03/17/26 by Callsign W6XI, Modified on 04/05/26 - IP: ip68-109-162-111.ph.ph.cox.net
Click to Contact -- Click Here to View Picture -- Send this Ad to a Friend
RADIOHF - ICOM IC 756 PRO III
Up for grabs, is an Icom IC 756 PRO III with matching power supply unit, external speaker and SM 20 desk mic.
Radio and all components are in very nice shape, but the speaker has cosmetic damage. Does not affect function, speaker works great.
These matched components don't come up often, especially in nice condition.
Looking for $1100 plus shipping to your QTH.
No trades, unless it's a nice Yaesu FT 1000 Mark 5 with power supply, speaker and all filters.
Lowball offers will be ignored.
LOCAL PICKUP PREFERRED, since all of this would cost a small fortune to ship.
I don't need to sell, just putting feelers out.
Please call or e mail for questions.
Paypal, CashApp, personal check for payment. (PP add 6% for fees)
Thanks for looking!
Listing #1764142 - Submitted on 04/05/26 by Callsign KD9MAR - IP: 146.70.8.14
Click to Contact -- Click Here to View Picture -- Send this Ad to a Friend
|
= Ad was Edited or Renewed 
= Original Ad
