![]() |
A Free Service by KA9FOX & QTH.com |
Classifieds Home
- Feedback Forum
- Swap Chat Board
- Safe Trading Tips
Search Ads
- Place Ad
- Edit Ad
- Delete Ad
- Callsign Lookup
- Make Donation
Contact KA9FOX
- Banner Advertising
- Web Hosting
- Ham Radio Homes
Displaying ads 1 to 10 of 3652 ads matching your search
= Photo available, click to view
= Ad was Edited or Renewed
= Original Ad
. MIGHT be interested in other items. Best price shipped please. . . ONLY replies through QTH system and MUST be good on QRZ....Thanks! $225 EA. Shipped US VHF: RF Concepts 2-315 40 in 170 out Mirage B3016 30 in 160 out UHF: Mirage D3010 30 in 100 out Pics available Elecraft Specs: Two sensors can be connected to the W2, to monitor different transmitters or amplifiers, switch-selected from the front panel. Uses standard CAT5 shielded or unshielded cables. The W2 can be configured to generate alarm outputs at a high SWR and includes an amplifier keying cutout relay. On any alarm condition, the amp’s key line can be broken, preventing possible damage to sensitive equipment. The W2’s built-in RS232 port allows you to use a computer to read both power and SWR with higher accuracy, as well as to set and check alarms, turn the LEDs off, and other operations. $300 shipped continental US. No PayPal. Thanks and 73, Bob W3RW Late 1965 model, in very good condition and is 100% operational. - • 80-6 meters Ham-Bands. • AM/CW/SSB Modes. • All re-tubed, dial lamp and capacitors/resistors replaced. • Restored and fully aligned. • Original Operating & Service instruction manual. • Shipped double boxed, with Original factory container. - $270.00 shipped CONUS - Please contact me for enquiries. Thanks, John WY2G - =====FUNDS PENDING===== Icom IC-720 A HF transceiver For Sale: - The Icom IC-720A is an all solid state transceiver covering nine amateur HF bands. It features two digitally synthesized 10 Hz VFOs. Enhancements include RF speech processor, RIT, CW semi break-in, noise blanker and VOX. The IC-720A has has a quad- conversion, general coverage receiver that tunes 100 kHz to 30 MHz. Transmit on 160 thru 10 meters, including the WARC bands. - Power output is 100W on SSB/CW/RTTY, and 40W on AM. It requires 13 VDC at about 20 Amps. - Features: All Mode Analog S/RF Meter 160-10 Meters 10 Hz Tuning Variable RF Output 100 Hz Display VOX RF Speech Processor Dial Lock PBT RIT Noise Blanker - It requires a special mic with preamp built in to it, which is included. - This one works as it should, and looks extremely nice. Buy it with manual for $315 plus shipping from Florida. - Thanks. 73, Ken Simpson, W8EK Voice Phone (352) 732-8400 . - The TenTec 255 power supply is designed to provide 18 amps at 13.5 volts, which means it will power most 100 watt HF rigs. It also includes a built in speaker that has great fidelity. - Also included is an electronic latching circuit that will turn the power supply off if more than 20 amps is pulled from it. - The output is provided via a four pin AMP connector, as used on most of TenTec's HF transceivers. There are also two RCA phono sockets for low current use. - A front panel meter indicates current drawn. - This one works 100% as it should, and looks great. - Buy it with paper work for $125 plus shipping from Florida. - Thanks. 73, Ken Simpson, W8EK Voice Phone (352) 732-8400 . Yaesu FP-707, 20 Amp Speaker/Power Supply For Sale: - The Yaesu FP-707 is a 20 amp 13.8 Volt DC Power Supply, with a very nice front facing speaker in the same enclosure. - Cosmetically, it matches the FT-707, FT-747, FT-757 and likely others. - Electrically, it can provide up to 20 amps, so will work with most any HF and/or VHF rig. It also has a set of binding posts on the back for easy connection of a rig in addition to the HF rig. - The speaker has a 3.5 mm plug on it. - This particular unit is in very good shape both electrically and cosmetically. I can not find a scratch, dent, or ding on it. Electrically, it works as it should. - Buy this unit with manual for $115 plus shipping from Florida. - Thanks. 73, Ken Simpson, W8EK Voice Phone (352) 732-8400 . 13 V DC Power Supplies For Sale: - Staco RPS-4, 4 amp power supply This one is still in its original box, and even has the warranty card. I do not know if it is new or not, but it certainly looks like it might be. $30 - Micronta 22-124 A, 2.5 Amp regulated supply standard cabinet, $15 With large heat sink covering most of cabinet. $25 - Stinger PS-11, 4 Amp UNregulated Supply $15 - Stinger 6 amp UNregulated supply $20 - Prices do not include shipping from Florida. - Thanks. 73, Ken Simpson, W8EK Voice Phone (352) 732-8400 . |
Banner Advertising, along with Donations, keeps the QTH.com Classifieds free to use for everyone.
Please support the QTH.com Classifieds by allowing ads to be displayed. Here is how!
Or, for now, you may continue to use this site without unblocking ads.