Free Ham Radio Classified Ads
Ham Radio Classified Ads
A Free Service by KA9FOX & QTH.com

Classifieds Home - Feedback Forum - Swap Chat Board - Safe Trading Tips
Search Ads - Place Ad - Edit Ad - Delete Ad - Callsign Lookup - Make Donation
Contact KA9FOX - Banner Advertising - Web Hosting - Ham Radio Homes

5KW Half-Wave Dipole Flex-Weave Dual Core Current Balun
View All Banners     Advertise Here

HF Antennas

Displaying ads 11 to 20 of 145 ads in this category.
= Photo available, click to view      = Ad was Edited or Renewed      = Original Ad
KA9FOX Wishlist on Amazon.com

 MOSLEY S 402M DRIVEN ELEMENT INDUCTOR  
This inductor was redesigned and used on the S402 and S403, driven element, with great success. It is a balanced input to the antenna rather than the unbalanced, original inductor.
The unit will need to be sealed up before placing it out doors in the elements. The seal caps are available at most hardware stores that deal with PVC pipe. $35 Shipped. I take PayPal, PMO and check.


Listing #1768189 - Submitted on 05/16/26 by Callsign W6XI, Modified on 05/19/26 - IP: ip68-109-162-111.ph.ph.cox.net
Click to Contact -- Click Here to View Picture -- Send this Ad to a Friend

 ANTENNA MATCHING INDUCTOR  
This ceramic coil form, with link coil assembly coil wound on it was to be the matching assembly for a shortened 10 MHZ antenna. It could also be use to just add inductance to most any antenna. The form is 2.5 inces in diameter and has 32 groves for windings. The windings on the form are three turns for the Pimary link and 13 turns for the secondary winding. The windings are made of 10 and 14 Ga. solid copper wire. $20 shipped I take Paypal, Postal Mo and check

Listing #1768197 - Submitted on 05/16/26 by Callsign W6XI, Modified on 05/19/26 - IP: ip68-109-162-111.ph.ph.cox.net
Click to Contact -- Click Here to View Picture -- Send this Ad to a Friend

 72 Ft Tower and 4 El Steppir Beam pkg
72 ft Tower and Steppir system:
Tashjian
LM-470 Motorized crank-up with positive pull-down
Limit switches and base:
Tower was painted dark green after mfg.
RTL (Raise and lower from remote location, wired)
TB-2 Thrust bearing
AD-100H 10ft mast
TA 70L (LM354HD &LM470E
CDR rotor plate LM-470
CO-4 Stand off LM-470
Steppir: 4 element w/40M
4848 TS990 /Flex interface board
S18 Cable. 9 Pin RTS
S12 Cable 9 Pin crossed
SAA100 Tuning Relay (Xmit interlock)
SDA 100 Driver Board
6-20M 4 element SteppIR Yagi 36 ft boom
40 Meter delta loop
Truss kit for beam
16 conductor cable 225ft
Controller cable splice; 25 pin w/25 slot header
Connector Junction box 4 element
Green Heron RT-21 controller
Yaesu G-2800 Rotor w/ connectors
Includes all cables
Everything works as new.
Located in Eureka CA 95503
The cost for all items today less shipping is over $30,000.
Sell package (no partial sales) for $18,500.
Tower is on the ground and everything is packed for shipment.
Buyer must be present onsite


Listing #1768324 - Submitted on 05/17/26 by Callsign KY6N, Web Site: http://ky6n.com - IP: 47.208.133.116
Click to Contact -- Send this Ad to a Friend

 FOR SALE: Fluid Motion Controller  
SteppIR Fluid Motion controller for 3 element SteppIR. Works as it should. $200 shipped CONUS. Prefer Zelle or postal money order.

Listing #1764444 - Submitted on 04/08/26 by Callsign W7PV, Modified on 05/17/26 - IP: 38.188.154.27
Click to Contact -- Click Here to View Picture -- Send this Ad to a Friend

 For sale: M2 6M3 Antenna
This antenna was up for four years and is complete and works perfectly. M2 6M3. New from dx engineering they are $400. I will deliver this one to the Schertz hamfest on May 29-30 for $200. Or pickup outside of San Antonio. 73

Listing #1768233 - Submitted on 05/16/26 by Callsign KE5ZS - IP: syn-173-174-135-110.res.spectrum.com
Click to Contact -- Send this Ad to a Friend

 17/12M VERTICAL  
FS: WARC Band Vertical Antenna
A custom-made 17M / 12M Vertical antenna manufactured by Zero-Five Vertical Antennas. Built with .058” tubing, this vertical is solid & substantial. The 17M vertical is 14 FT in length allowing for tuning to the frequency most desired, and the 12/M is 10 FT. The two verticals are mounted upon a common SO239 with a fold-over base, making setup & tuning easy. No tuner is required on either band. The SWR is 1:1.5 or below. I use a pair of raised radials per band. The design schematic and a pic are attached. I will sell for $500 & share shipping.


Listing #1766892 - Submitted on 05/03/26 by Callsign K1ZN, Modified on 05/16/26 - IP: syn-035-129-189-022.res.spectrum.com
Click to Contact -- Click Here to View Picture -- Send this Ad to a Friend

 Icom AH-3, 14' mast, 9' radials, tripod  
Hello all. I'm stepping away from HF ham radio for a while due to tons of other projects and a need for space. The tripod is about 12 feet tall. I welded it up out of bed frame steel. The mast and ground plane radials all come apart. strong aluminum tubing with stainless screws. I think I did it all in 1/2-13. I ran this with an IC-7300HF rig, had a blast. Tuned most anywhere I wanted it to. No issues. Pickup only please.

Listing #1768173 - Submitted on 05/16/26 by Callsign K5NJP - IP: c-73-72-4-149.hsd1.il.comcast.net
Click to Contact -- Click Here to View Picture -- Send this Ad to a Friend

 Alpha Delta Antenna Switches  
4 Alpha Delta 4B switches and 1 Alpha Delta 2B no ark plugs in units since new. You send money, I send switch.
Each shipped con US $70


Listing #1768123 - Submitted on 05/15/26 by Callsign K4JPD - IP: 107-199-234-235.lightspeed.tukrga.sbcglobal.net
Click to Contact -- Click Here to View Picture -- Send this Ad to a Friend

 WARC Band 2 Element Vertical Antenna  
FS: WARC Band Vertical Antenna
A custom-made 17M / 12M 2-element Vertical antenna manufactured by Zero-Five Vertical Antennas. Built with .058” tubing, this vertical is solid & substantial. The 17M vertical is 14 FT in length allowing for tuning to the frequency most desired, and the 12/M is 10 FT. The two verticals are mounted upon a common SO239 with a fold-over base, making setup & tuning easy. No tuner is required on either band. I use a pair of raised radials per band. The SWR is 1:1.5 or below. The design schematic and a pic are attached. I will sell for $500 & share shipping. Contact Jeff / K1ZN jacantor9 at Gmail.com


Listing #1767824 - Submitted on 05/11/26 by Callsign K1ZN, Modified on 05/15/26 - IP: syn-035-129-189-022.res.spectrum.com
Click to Contact -- Click Here to View Picture -- Send this Ad to a Friend

 FOR SALE: Coax Antenna Switch 2 Position  
This coax antenna switch is in great working condition Price is $55 plus FREE SHIPPING to the CONUS. Payment using Zelle or USPS Money Order. No PayPal. No Refunds. 73’s Norm K9CQ

Listing #1768069 - Submitted on 05/14/26 by Callsign K9CQ - IP: 38-34-96-167.starry-inc.net
Click to Contact -- Click Here to View Picture -- Send this Ad to a Friend


BackPrevious 10 AdsNext 10 AdsNext

W6LVP Magnetic Loop Receive Antennas - Over 1000 Sold
View All Banners     Advertise Here

Classifieds Home - Feedback Forum - Swap Chat Board - Safe Trading Tips
Search Ads - Place Ad - Edit Ad - Delete Ad - Callsign Lookup - Make Donation
Contact KA9FOX - Banner Advertising - Web Hosting - Ham Radio Homes

© 2026. The QTH.com Ham Radio Classified Ads website is Created and Maintained by Scott Neader, KA9FOX.

4.7820 ms (0.0048 secs)

Free Ham Radio Classified Ads

Uh oh! It looks like you’re using an ad blocker.

Banner Advertising, along with Donations, keeps the QTH.com Classifieds free to use for everyone.
Please support the QTH.com Classifieds by allowing ads to be displayed. Here is how!

Or, for now, you may continue to use this site without unblocking ads.