Free Ham Radio Classified Ads
Ham Radio Classified Ads
A Free Service by KA9FOX & QTH.com

Classifieds Home - Feedback Forum - Swap Chat Board - Safe Trading Tips
Search Ads - Place Ad - Edit Ad - Delete Ad - Callsign Lookup - Make Donation
Banner Advertising - Web Hosting - Domain Names - Ham Radio Homes

View All Banners     Advertise Here

Contact This Person

In an effort to reduce spam and the spread of viruses, we are now providing this form for you to contact a person that has placed an ad on QTH.COM. After submitting this form, an e-mail will be generated and sent to BOTH you and the person that placed the ad. The e-mail will contain a copy of the ad, plus your e-mail information and your comments.

NOTE -- BEFORE YOU RESPOND:

  1. Please Read the Safe Trading Tips article from KA9FOX.
    Link opens up a new window, so you can come back to this ad later
  2. Use the Feedback Forums to see if the person you are about to deal with has any good or bad feedback from previous dealings.
    Link opens up a new window, so you can come back to this ad later
You are responding to the following ad:

Ad Number:1471392
Date Placed:01/03/20
Name:Jerry wothe
Phone Number:E-MAIL ONLY
Callsign:W6XI
Category:ROTATORS
Heading:FS: M2 OR2800DC ANTENNA POSITIONER SYSTE
Ad Message:This antenna positioner(rotor) is a very heavy duty system for turning your big antenna systems.
The unit is in very nice condition showing minimal wear and tear from the weather. The rotor unit comes with a pigtain with connector and also included is 100 feet of control cable with the mating connector for the pig tail on the rotor.
This rotor is rated at 35 Sq Ft. wind area capacity.
Starting torque 4200 in. lb.
Rotating torque 3200 in. lb.
1800 lbs vertical load
Mast size O.D. 1.75 to 3-1/8 in
Rotation range 360 deg +/- 14 deg.
The controller for this rotor is the M2 RC2800P-A Programmable Azimuth control unit with RS232 port.
The control has three RUN modes that activate the positioned with manual or preset commands. There are additional Programmable preset modes where one can preset selectible headings desired.
The control unit is in excellent condition and the two units have been tested together to verify proper operation. $1250 plus shipping. I take check, MO and PayPal +3%

Your Response to this Ad:

Due to the amount of non-ham scammers trying to respond to the ads, I am now asking a simple question that ham operators should easily be able to answer, but scammers may not know the answer: What is the number that hams use to represent the phrase "Best Regards"? This number is typically transmitted by hams at the end of a QSO.
Best Regards:

Your Name:
Your Callsign:
Your E-mail Address:
Your E-mail Address Again:
Your IP Address:34.229.131.116
  Save my information for me! 
Your message:

 

National Radio Data
View All Banners     Advertise Here

Classifieds Home - Feedback Forum - Swap Chat Board - Safe Trading Tips
Search Ads - Place Ad - Edit Ad - Delete Ad - Callsign Lookup - Make Donation
Banner Advertising - Web Hosting - Domain Names - Ham Radio Homes

© 2019. The QTH.com Ham Radio Classified Ads website is Created and Maintained by Scott Neader, KA9FOX.

38.1160 ms (0.0381 secs)

Free Ham Radio Classified Ads

Uh oh! It looks like you’re using an ad blocker.

Banner Advertising, along with Donations, keeps the QTH.com Classifieds free to use for everyone.
Please support the QTH.com Classifieds by allowing ads to be displayed. Here is how!

Or, for now, you may continue to use this site without unblocking ads.