Ham Radio Classified Ads A Free Service by KA9FOX & QTH.com

Classifieds Home - Feedback Forum - Swap Chat Board - Safe Trading Tips
Search Ads - Place Ad - Edit Ad - Delete Ad - Callsign Lookup - Make Donation
Contact KA9FOX - Banner Advertising - Web Hosting - Ham Radio Homes

View All Banners     Advertise Here

In an effort to reduce spam and the spread of viruses, we are now providing this form for you to contact a person that has placed an ad on QTH.COM. After submitting this form, an e-mail will be generated and sent to BOTH you and the person that placed the ad. The e-mail will contain a copy of the ad, plus your e-mail information and your comments.

NOTE -- BEFORE YOU RESPOND:

1. Please Read the Safe Trading Tips article from KA9FOX.
   Link opens up a new window, so you can come back to this ad later
2. Use the Feedback Forums to see if the person you are about to deal with has any good or bad feedback from previous dealings.
   Link opens up a new window, so you can come back to this ad later

You are responding to the following ad:

Ad Number:	1711525
Date Placed:	12/09/24
Name:	Young Kim
Phone Number:	650-380-0126
Callsign:	K6HM
Category:	RADIOANQ
Heading:	FS: 275V regulator 4 516F-2 and PM-2 PS
Ad Message:	Due to the old 1956 design of 516F-2, or PM-2 power supply for Collins KWM-2 (A) or 32S series transmitters runs on 125V AC power Voltage, the 516F-2 supply should deliver 275V Low Volt becomes 330V Plus minus during receive mode of KWM-2(A), vacuum tubes get 330V which will shorten life of tubes and cause extreme hot temperatures affect other parts. KWM-2(A)and 32S series transmitter get lot of heat problems. I have a solution to keep the LV to exactly 275V either transmit or receive mode.Using 500V MOSFET and series of Zener regulators,LV is now tightly regulated which helps keep the VFO with no drift and no audio hum as it works as ripple filter.The board is 22mm x 30 mm by size, made with SMD components and can be fit to the sidewall of power supply. Price is $40 plus $6 for USPS. two or more it has to be shipped by priority, price is $13.check to my QRZ.com address.Other output V,150V or 250V or 300V if needed.

Your Response to this Ad:

Due to the amount of non-ham scammers trying to respond to the ads, I am now asking a simple question that ham operators should easily be able to answer, but scammers may not know the answer: What is the number that hams use to represent the phrase "Best Regards"? This number is typically transmitted by hams at the end of a QSO.
Best Regards:
Your Name:
Your Callsign:	(Enter NONE if you have no call)
Your E-mail Address:
Your E-mail Address Again:
Your IP Address:	3.149.240.101
Please forget all information you have automatically stored about me in cookies.
Your message:
BUY / SELL / TRADE SAFELY! I agree that I have read KA9FOX's Safe Trading Tips HERE (link opens in new tab).

View All Banners     Advertise Here