Free Ham Radio Classified Ads
Ham Radio Classified Ads
A Free Service by KA9FOX & QTH.com

Classifieds Home - Feedback Forum - Swap Chat Board - Safe Trading Tips
Search Ads - Place Ad - Edit Ad - Delete Ad - Callsign Lookup - Make Donation
Contact KA9FOX - Banner Advertising - Web Hosting - Ham Radio Homes

View All Banners     Advertise Here

Contact This Person

In an effort to reduce spam and the spread of viruses, we are now providing this form for you to contact a person that has placed an ad on QTH.COM. After submitting this form, an e-mail will be generated and sent to BOTH you and the person that placed the ad. The e-mail will contain a copy of the ad, plus your e-mail information and your comments.

NOTE -- BEFORE YOU RESPOND:

  1. Please Read the Safe Trading Tips article from KA9FOX.
    Link opens up a new window, so you can come back to this ad later
  2. Use the Feedback Forums to see if the person you are about to deal with has any good or bad feedback from previous dealings.
    Link opens up a new window, so you can come back to this ad later
You are responding to the following ad:

Ad Number:1749831
Date Placed:11/17/25
Name:Justus Brammeier
Phone Number:E-mail only
Callsign:N7JFB
Category:AMPHF
Heading:MX-P50M
Ad Message:This was my trial run with a 45W amp for my x6100. It didn't prove itself well enough during testing. I'm doing better with 10W than with an amp apparently. During initial testing, I'm pretty sure I did some damage to the finals, so I got help replacing that part. I'm including a spare since I bought 2. I know this does amplify, but there could still be something else going bad inside. Not sure. I don't have the gear to properly measure or analyze it. Power connector & PTT cables included. I wired them up for PP & 3-pin jack respectively. Both have proven they work. Asking $150. I'll handle shipping, lower 48 only.

Your Response to this Ad:

Due to the amount of non-ham scammers trying to respond to the ads, I am now asking a simple question that ham operators should easily be able to answer, but scammers may not know the answer: What is the number that hams use to represent the phrase "Best Regards"? This number is typically transmitted by hams at the end of a QSO.
Best Regards:

Your Name:
Your Callsign: (Enter NONE if you have no call)
Your E-mail Address:
Your E-mail Address Again:
Your IP Address:216.73.216.40
  Please forget all information you have automatically stored about me in cookies.
Your message:

BUY / SELL / TRADE SAFELY!
I agree that I have read KA9FOX's Safe Trading Tips HERE (link opens in new tab).


 

Troubleshoot and Test SteppIR Antennas and Controllers
View All Banners     Advertise Here

Classifieds Home - Feedback Forum - Swap Chat Board - Safe Trading Tips
Search Ads - Place Ad - Edit Ad - Delete Ad - Callsign Lookup - Make Donation
Contact KA9FOX - Banner Advertising - Web Hosting - Ham Radio Homes

© 2025. The QTH.com Ham Radio Classified Ads website is Created and Maintained by Scott Neader, KA9FOX.

1.8182 ms (0.0018 secs)

Free Ham Radio Classified Ads

Uh oh! It looks like you’re using an ad blocker.

Banner Advertising, along with Donations, keeps the QTH.com Classifieds free to use for everyone.
Please support the QTH.com Classifieds by allowing ads to be displayed. Here is how!

Or, for now, you may continue to use this site without unblocking ads.